MIL-P-80026C
otherwise
3.2.2 Measuring and indicatin g device calibrations. Unless
specified, either the inch-pouno or the SI system of measurement shall be used
to graduate measuring and indicating devices. When only one system of
graduation is acceptable, the particular graduation required shall be as
(see 6.2.1). Regardless of the measurement system used, all
specified
measuring and indicating devices on the machine shall be graduated in the same
When specified (see 6.2.1), measuring and indicating devices shall be
system.
graduated to read in both the inch-pound and the SI system of measurements.
All dials used to indicate machine axes position or
3.2.2.1 Dials.
workpiece movement shall be graduated in Increments not larger than 0.001
inch. Dial and handwheel circumferences shall be permanently and legibly
engraved or etched on a nonglare background with graduations that can be read
from the operator's normal operating position.
3.2.3 Reclaimed materials. The punching machine may contain reclaimed
materials provided such materials will not jeopardize the intended use,
performance, and design life of the machine. The reclaimed materials shall
have been reprocessed, remanufactured, or recycled in a manner which will
restore them to the same chemical composition and physical properties as the
materials originally selected for use on the machine.
The punching machine and its components that
3.2.4 Energy efficiency.
directly consume energy in normal operation shall be designed and constructed
for the highest degree of energy efficiency as governed by the latest
developments available within the industry.
pneumatic
operating
and
3.2.5 Controls. All mechanical, hydraulic,
controls shall be located conveniently to the operator's work station.
3.2.6 Safety and health requirements. All parts, components, mechanisms,
and assembl ies furnished on the machine, whether or not specifically required
herein, shall comply with all requirements of 29 CFR 1910. Additional safety
and health requirements shall be as specified in detail (see 6.2.1).
Covers, guards, or other safety devices normally
3.2.6.1 Safety guarding.
furnished as standard on the manufacturer's commercial machine supplied to the
commercial market shall be provided for the point of operation and all other
parts of the machine that present safety hazards. The safety devices shall
prevent unintentional contact with the guarded part and shall be removable to
facilitate inspection, maintenance, and repair of the parts. The safety
devices shall not interfere with the operation of the machine. If specific
point-of-operation guarding dependent on workpiece size and configuration is
required, the procuring activity shall specify the exact configuration of the
guard required (see 6.2.1).
3.2.7 Mercury restriction. The punching machine shall not contain mercury
of mercury compounds nor be exposed to free mercury during manufacture.
3.2.8 Asbestos restriction. Asbestos and materials containing asbestos
shall not be used on or in the punching machine.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business