MIL-P-80054D
3.2.1.1 Measuring. and indicating device calibrations. Unless
otherwise
.
required, either the inch-pound or the SI system of measurement shall be used
to 'graduate measuring and" indicating devices When only one system of
graduation is acceptable, the particular graduation required shall be as spec-
ified (see 6.2.1).' Regardless-of the measurement system used, all measuring
and indicating devices on the machine shall be graduated in the same system.
3.2.2 Reclaimed materials. The punching machine may contain reclaimed
materials provided such materials will not jeopardize the intended use and
performance of the machine. The reclaimed materials shall have been repro-
cessed, remanufactured, or recycled in a manner which will restore them to the
same chemical composition and physical properties as the materials originally
selected for use on the punching machine.
3.2.3 Energy efficiency. The punching machine and its components that di-
rectly consume energy in normal operation shall be designed and constructed
for the highest degree of energy efficiency as governed by the latest develop-
ments available within the industry.
3.2.4 Controls. All operating controls
shall be located conveniently to
the operator at his normal work station.
3.2.5 Safety and health requirements. Covers, guards, or other safety de-
vices shall be provided for all parts of the punching machine that present
safety hazards, The safety devices shall not interfere with the operation of
the punching machine. The safety devices shall prevent unintentional contact
with the guarded part, and shall be removable to facilitate inspection,
maintenance, and repair of the parts. All parts, components, mechanisms, and
assemblies furnished on the punching machine, whether or not specifically re-
quired herein, shall comply with all of the requirements of (OSHA) 29 CFR
1910 that are applicable to the machine itself. The punching machine shall be
equipped with all point-of-operation guarding normally furnished as standard
on the manufacturer's commercial punching machine supplied to the commercial
market. If specific point-of-operation guarding is required, the procuring
activity should specify the exact configuration of the guard required because
the guard configuration is dependent on the size and configuration of the
workplaces. Additional safety and health requirements shall be as specified
(see 6.2.1).
3.2.6 Mercury restriction. The punching machine shall not contain mercury
or mercury compounds nor be exposed to free mercury during manufacture.
3.2.7 Asbestos restriction. Asbestos and materials containing asbestos
shall not be used on or in the punching machine.
3.2.8 Environmental protection. The punching machine shall be so designed
and constructed that, under the operating, service, transportation, and stor-
age conditions described herein, the punching machine shall not emit materials
hazardous to the ecological system as prohibited by Federal, state, or local
-
statutes in effect at the point of installation.
3.2.9 Lubrication. An automatic lubricating system shall be provided for
all parts and mechanisms requiring a continuous flow of lubricating oil.
Means for determining oil level in each reservoir shall be an oil level sight
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business