MIL-P-45042F
6.1 Intended use. The machine covered by this specification is intended
for use in punching, notching, coping, and shearing bars and structural shapes
of various netals. This machine is intended for use in manufacturer's plants
and military and contractor's repair shops.
Acquisition documents should specify the
6.2 Acquisition requirements.
following:
a.
Title, number, and date of this specification.
b.
Size required (see 1.2).
c.
Issue of DODISS to be cited in the solicitation and, If
required, the specific issue of individual documents referenced
(see 2.1.1 and 2.2).
First article, if required (see 3.1).
d.
e.
Number of machining stations, if different (see 3.2).
f.
Specify machining operations, if different (see 3.2).
System of units for measuring and indicating devices
9"
(inch-pound) (see 3.2.1).
h.
Specify two anti-repeat foot switches, if required (see 3.2.4).
Additional safety and health requirements, if required
i.
(see 3.2.5).
Specify configuration of additional point-of-operation
j.
guarding, if required (see 3.2.5.1).
k.
Specify noise level, if different (see 3.2.5.2).
1.
Specify specific environmental protection requirements
exceeding established EPA and OSHA requirements, when
required (see 3.2.8).
m.
Lubrication system, if different (see 3.2.9).
n.
Specify surface finish requirements, if different (see 3.3.3).
o.
Painting, If different (see 3.3.5).
If electromagnetic interference control is required, specify
p.
the equipment and subsystems class and the emission and
susceptibility required (see 3.3.8).
Specify sizes and shapes of punches and dies, when required
q.
(see 3.4.3.4).
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business