MIL-P-45042F
3.2.10 Interchangeability. All parts having the saw manufacturer's part
number shall be functionally and dimensionally interchangeable. All parts
shall be manufactured to such standards as will permit replacement or
adjustment without modification of parts or machine.
3.3 Construction. The machine shall be constructed of parts which are
new, without defects, and free of repairs. The structure shall withstand all
forces encountered during operation of the machine to its maximum rating and
capacity without permanent distortion or failure.
3.3.1 Castings and forgings All castings and forgings shall be free of
defects, scale, and mismatching. No processes such as welding, peening,
plugging, or filling with solder or paste shall be used for reclaiming any
defective part. Such processes may be used only for enhancing surface finish
and appearance.
3.3.2 Fastening devices. All fasteners shall be installed to prevent
change of tightness. Fastening devices subject to removal or adjustment shall
not be pertinently installed.
3.3.3 Surfaces. All surfaces shall be clean and free of harmful or
extraneous materials. All edges shall be either rounded or beveled unless
sharpness is required to perform a necessary function. Except as otherwise
specified herein (see 6.2), the condition and finish of all surfaces shall be
in accordance with the manufacturer's commercial practice.
3.3.4 Welding, brazing, or soldering. Welding, brazing, or
soldering
shall be employed only where specified in the original design. None of these
operations shall be employed as a repair measure for any defective part.
Unless otherwise specified (see 6.2), the paint color
3.3.5 Painting.
and application shall be in accordance with the manufacturer's commercial
practice.
3.3.6 Threads. All threaded parts used on the machine and its related
attachments and accessories shall conform to FED-STD-H28 and the applicable
"Detailed Standard" section referenced therein.
3.3.7 Drive train gears. All gears of the drive train shall conform to
or exceed all provisions of AGMA 390.03a, AGMA 2001-B88, and AGMA 2000-A88 for
the inch-pound system of measurennt or ISO 54 for the metric system of
measurment.
The gears shall be manufactured of a suitable ferrous material.
The gears shall be of proper width and size to transmit full-rated torque and
horsepower throughout the speed ranges without failure for the expected
service life of the machine.
3.3.8 Electro magnetic interference control. When specified (see 6.2),
equipment furnished under
this specification shall comply with MIL-STD-461.
The equipment and subsystem(s) class and the emission and susceptibility
requirements shall be as specified.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business